Hall Ticket No Question Paper Code: AME001
INSTITUTE OF AERONAUTICAL ENGINEERING
(Autonomous)
B.Tech I Semester End Examinations (Supplementary) February, 2018
Regulation: IARE-R16
ENGINEERING DRAWING
(Common to AE ME CE)
Time: 3 Hours Max Marks: 70
Answer ONE Question from each Unit
All Questions Carry Equal Marks
All parts of the question must be answered in one place only
UNIT I
1. Construct a diagonal scale of S.F 1/(2.5 x 10) to read up to a single kilometer and long enough
to measure 400 km. Mark a length of 254 km on it.
Construct a parabola in a parallelogram of side 100 mm x 60 mm and with an included angle of
750.
2. The major and minor axes of an ellipse are 120 mm and 80 mm. Draw an ellipse by oblong
method.
Draw the involute of an equilateral triangle of side 20 mm.
UNIT II
3. The top view PQ of a straight line is 70 mm long and makes an angle of 600 with the XY line. The
point Q is 10 mm in front of VP and 30 mm above HP. The difference between the distances of P and
Q above the HP is 45 mm. Draw the projections and traces. Determine its true length.
4. A 300-600 set square with longest side measuring 125 mm is placed such that the longest side is in
HP, making an angle of 300 with VP. The surface of the set square is inclined at 450 to HP. Draw its
projections.
UNIT III
5. A pentagonal pyramid 30 mm side of base and axis 50 mm is resting on HP on one of its base edges
such that the triangular face containing that edge is lying on HP. Draw the projections of the pyramid
when the axis is inclined to VP at 450.
6. A hexagonal prism of 25 mm side of base and height 50 mm rests on one of its edges on HP such that
the axis is inclined at an angle of 450 to HP. Draw the projections of the prism when the axis appears
to be inclined to VP at 400.
Page 1 of 2
UNIT IV
7. A cone of base 50 mm diameter and axis 60 mm long, is resting on its base on HP. It is cut by a section
plane, perpendicular to VP and parallel to an extreme generator and passing through a point on the
axis at a distance of 20 mm from the apex. Draw the development of the retained solid.
8. A hemisphere of diameter 50 mm is resting on its curved surface centrally on the top face of the
frustum of a rectangular pyramid of base 80 mm x 60 mm and top 60 mm x 40 mm having height 55
mm. Draw the isometric projections of the combination.
UNIT V
9. Convert the isometric projection of the given Figure 1 into orthographic projections by drawing the
front view, top view and side view.(All dimensions are in mm)
Figure 1
10. Convert the isometric projection of the given Figure 2 into orthographic projections by drawing the
front view, top view and side view.(All dimensions are in mm)